OctoPrint

• Print finishedRuns when a print finishes, with the file, how long it took and the filament it used, even a short print that started and ended between two looks. Prints from the printer's SD card aren't seen.
• Print failed or cancelledRuns when a print stops before the end: cancelled, or failed because the printer reported an error, or only one of the two. Each run says which, and the printer's error.
• Print pausedRuns when a print is paused, from OctoPrint, by the printer (such as for a filament change) or by another app, with how far along it is. A pause shorter than the workspace's polling interval may be missed.
• Printer disconnected or errorRuns when the printer disconnects from OctoPrint (turned off, unplugged or disconnected) or reports an error, or only on errors, with the printer's state and error.

• Get printer statusFind out what the printer is doing: its state, temperatures, the file printing, how much is done and the time left, with one sentence saying it all for a message.
• Upload filePut a G-code file in OctoPrint, from an upload, an earlier step, a link or G-code written here, into a folder, and start printing it if you choose. A file of the same name is replaced.
• Start printStart printing a G-code file already in OctoPrint. The printer must be connected and not printing.
• Pause printPause the print, such as to change filament. A print already paused stays paused.
• Resume printCarry on with a paused print. A print already running carries on.
• Cancel printStop the print for good. It can't be resumed; the file stays in OctoPrint to print again.
• Set temperaturesHeat the nozzle, bed or chamber to a temperature, such as to preheat before a print, or turn one off with 0. Heaters left blank keep theirs.
• Cool downTurn off every heater: the nozzles, the bed and any chamber.
• Home axesMove the print head to its home position, on every axis or some. The printer moves, so make sure nothing is in its way.
• Send G-codeSend G-code commands to the printer, such as M117 to show a message on its screen. Commands can move the printer and heat it, so send only ones you know.
• Connect printerConnect OctoPrint to the printer, such as after it was turned on, and wait until it's ready. A printer already connected stays as it is.
• Disconnect printerDisconnect OctoPrint from the printer, such as before turning it off. Refused while it prints.
• List filesList the G-code files in OctoPrint, with how long each should take to print, the filament it uses, and how often it has printed.
• Delete fileDelete a G-code file from OctoPrint, such as once it has printed. A file that isn't there is left alone, and one printing is refused.
• Get webcam snapshotTake a picture with the webcam OctoPrint uses, saved as a file to send or attach, such as to see how a print is going.

No actions match that.